It takes a few seconds to setup and you will get full control over your serial ports with just a few. Serial Port Control allows you to overcome the complexity of the Win32 Serial Communications API. I have also tried other JDM-compatible programming software such as ICprog, althogh it does not have 18F2550 support, I wanted to make sure the circuitry was ok, and the LED gives light when performing actions but result is the same: it fails writing operation. Serial Port Control is an easy-to-use Software Developer Kit (SDK) created to simplify serial port communication tasks in your projects. I have double-checked and confirmed that all connections are correct.
at *hardware test* it says "ERROR -> hardware is not responding"Įrasing works without error messages, also read works but LED does not give away any light in WinPIC800 (It did when performing any action but I found out I had bad connection in 10k resistor to ground and it just stays off since connection was fixed) Operation Rname, Cname, Tname, name these variables is a power failure to save That is, when the system is powered down, Sun Feb 26 2012, 185740, 4 replies. at *detect PIC* it says "DETECTED -> unknown" on the status log window It is also fully compatible with Microchips MPLAB IDE as it appears as the original PicKit2 and threfore can program all popular PIC Microcontrollers including. MB PonyProg is a serial device programmer software with a user friendly GUI framework available for Windows9598MENT2000. Newbie Offline Posts: 29 Thank You-Given: 61-Receive: 2.
Should be 5v but anywhere between 4.5 and 5.5 sohuld be fine. I've assembled your JDM programmer but I cannot seem to make it work properly after PC connection is made, perhaps you could enlighten me? Topic: PIC16F84 -> PIC16F628A programmer (Read 12844 times) 0 Members and 1 Guest are viewing this topic. 1) make sure the VDD to the PIC is at least 4.5V.
0 kommentar(er)
